Idec DATAVS1 Series Manual de usuario descargar pdf (Pagina 49)

Instruction Manual SVS1 Series

The image is now acceptable, so we must resize and position the ROI accordingly: follow the

instructions provided previously during this procedure.

We can access the Adjust mode by pressing the STATUS button. If the control fails even when

there is a stamp, increase the control sensitivity a little to raise the contrast between the stamp

and the envelope. To do this use the RIGHT ARROW to view the sensitivity setting and then use

the ARROW UP button to increase the value.

Now press the STATUS button to enter Monitor Mode and check that the tool functions properly.

The sensor now behaves as required. As the result is satisfying, press STATUS again and move

on to defining the behaviour of the outputs.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 82 83

Sin comentarios

Idec DATAVS1 Series Manual de usuario Pagina 49